• TEC Lighting UV Coater Model MegaCoat 45 Supreme Series (New 2018) with UV/IR #MC4030-2 Conveyor Combo, Feeder #MC4530FS, New Design 40" x 54" Deep Pile- Pallet Load & Unload, Max Sheet Size 42"W x 54”L, Min Sheet Size 16”W x 28”L, Max Speed: 7000 SPH, Application: Nonskid UV Coating and Curing - Pre Auction Offers Considered Call Tom Gagliardi at 203-641-2216
• Conflex Form Fill & Seal Machine Model SL240 (New 2017), Horizontal Servo Based High Speed Machine, 15’ Flighted Infeed, Intelli Touch HMI Controls, VFD Positive and Negative Bunching, 24” Teflon/Ceramic Coated Steel Heat Seal Knife, Max Film Speed: 90 FPM, Thermal Bottom Seal, Product Counter, Seal Bar, Dual Roll Low Film Alarm, Film Splicing, MBO B32 Folder, Economet ST1250 Stream Feeder, Markam T60-1400 Diamond Shrink Tunnel - MACHINE VIDEO - Pre Auction Offers Considered Call Tom Gagliardi at 203-641-2216
• Polar Mohr 45” Paper Cutter Model 115EM, S/N 6331072 (New 1993), Air Bed Table, Programmable Control
• Polar Mohr Paper Lift Model LW1000-4, S/N 7672213 (New 2006)
• Como Maskin 59” Cutter S/N 2937 with 79” Bed
• HP Scitex Wide Format Printer Model FB550 (New 2018), S/N SG62311002, Product# L1Q41A
• Hickok Round Corner Machine S/N 15678, 2-Side with 5” Lift
• Col-Tech Collator Model ABL Duplex S/N CR1608-6-12
• 3M-Matic Case Sealer Model 7000A3 Pro (New 2017)
• Lantech Rotary Stretch Pallet Wrapper Model QL400 (New 2020), 60” Dia, 1PH
• Crown 3000 lb Electric Walk Behind Forklift Model SX3000 (New 2017), 24 Volt, Triple Mast, 154” Lift Height
• Crown 4000 lb Electric Forklift Model SC5245-40 (New 2017) 36/48V, 3-Wheel, Side Shifter, 172” Lift Height
• Emax 5 HP Air Compressor, 80 Gallon with Emax Air Dryer

MUCH MORE!! TOO MUCH TO LIST!!

836 Grundy Avenue
Holbrook, New York 11741

First Lot Closes: Thursday, March 7, 1:00 PM (ET)
Lots have 1-minute staggered closing times with 1-lot closing every minute

Buyers are fully responsible for all rigging and shipping costs. We strongly recommend buyers obtain rigging quotes prior to bidding and confirm the rigging company can remove the intended purchases prior to the final removal date. Riggers listed on our site are not exclusive, buyers may use any rigging company of their choice as long as they provide Thomas Industries with satisfactory liability insurance.

For Rigging Quotes Contact:

C.A.S. Rigging 
Roand Eastman
Phone: 603-491-2450 
roland@casrigging.com

Registration Deposit / Bidder Approval.  All bidders that aren't pre-approved by Thomas Industries will be required to provide a refundable deposit, prior to being approved for bidding.  The deposit must be  25% of the amount the bidder is looking to be approved for bidding up to.  Thomas Industries, at their sole discretion, reserves the right to deny bidding privileges to any customer. For information on bidder Approval or to provide a registration deposit contact Irina Lekhmus (email: irina@thomasauction.com or Phone: 203-458-0709).

Currency:  (USD).  This auction will be conducted in United States currency (USD)

Buyer's Premium: 18%

Staggered Closing Times: Lots Have 1-Minute Staggered Closing Times.

Auto Extend Bidding: If a bid is submitted with less than 3-minutes remaining, the closing time for that lot will be extended by 3-minutes.

Payment Due In Full: Friday, March 8, 2024

Payment Types:  Certified Check, Wire Transfer, E-Check (ACH) or Crypto (BTC/ETH)

As-Is Where-Is:  All Items Are Sold "As-Is Where-Is" With No Warranty or Guarantee of Operating Condition.  Auctioneer Strongly Recommends That Buyers Inspect Equipment Prior to Bidding.

Removal: Removal Monday, March 11 through Friday, March 15. Removal Hours 9 am to 4 pm (M-F). Removal after March 15 by appointment only.   Any items not removed by this date will be considered abandoned and bidder will forfeit all right to any items not removed, including all deposit or  payment monies

Removal Costs: Buyers are fully responsible for all cost to remove their purchases.  Please get removal quotes prior to bidding and bid accordingly.  

Legally Binding Contract:  All bids constitute a legally binding contract and bidders will be legally obligated to make payment and remove items in accordance with the terms and conditions of the sale.